Lencore n.Form: MPI-6 Uživatelský manuál stáhnout pdf (Strana 10)

section 2

2.5 | mic paging

1. Connect a MIC to Lencore’s MIC pre-amp.

2. Connect the audio output of the MIC pre-amp to one of the six audio inputs of the MPI.

3. Connect the MIC switch wires to one of the six “Page on/off Inputs” terminal blocks.

Each terminal block will trigger a specific page zone as follows:

• Input 1 = all-call

• Input 2 = zone 251

• Input 3 = zone 252

• Input 4 = zone 253

• Input 5 = zone 254

• Input 6 = zone 255

4. Press the MIC key and make the page.

Note: The zones must be configured with Lencore’s Sound Manager or Reports software (iNET only). For iNET, use

audio input 6 for MIC paging.

figure 3 - page on/off inputs

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17

Žádné komentáře

Lencore n.Form: MPI-6 Uživatelský manuál Strana 10